What If? Garage
PlanningMazda MX-5 (NC2)

Engine & driveline

2.3L EcoBoost via custom adapter plate to the stock 6-speed and differential

Running today on a 2.5L Duratec swap at about 200 whp. The second swap, to a 2.3L EcoBoost through a custom adapter plate, is planned; the adapter plate isn't made yet.

Swapped once, swapping again

The stock 2.0L put a connecting rod through the block at 70 mph on the freeway. The 2.5L Duratec that replaced it won partly on cost and partly because it helped with California smog rules at the time.

Those rules no longer apply, and the Duratec is a naturally aspirated engine turbocharged after the fact, with a real ceiling and a thin aftermarket. The 2.3L EcoBoost comes turbocharged from the factory, has forged internals in the HPP version, a deep aftermarket and documented swaps by other builders.

A deliberate power ceiling

The target is 250 to 260 whp, up from about 200. More than the car and driver can use on a canyon road makes the car harder to drive fast, not easier.

Keeping the stock driveline

A custom adapter plate mates the EcoBoost to the stock NC 6-speed. A Ford 8.8 rear end and a built MT82 were both researched and set aside: at this power level the stock driveline isn't the weak point, and moving the differential would mean redesigning how the NC supports its transmission.

Photos

Photos go up here as the work happens.

Progress

Updates will show up here as work on this part of the build starts.